Here you can input the modification of the distance of the marked block in percent values. A value larger than 100% calculates more stitches into the design, the distance between the stitches becomes smaller. A value below 100% results less stitches and therefore a larger distance between the stitches.


Satin- and step stitch distance can be input individually. If the satin distance is defined, the step distance is set to the same value, but it could be altered afterwards.

Note: If a design should be calculated which obviously consists exclusively of step stitches also the satin stitch distance should set to the desired value. The reason is that the distance adjustment recognises small parts of step areas with a small number of stitches as satin areas. These are not correctly adjusted in distance otherwise. 

This function should be used exclusively if you do not want to change the size of the design, but only the distance. The modification of the size can be defined in the module mode with the parameter-box0FKBYC 


Created with the Personal Edition of HelpNDoc: Effortlessly upgrade your WinHelp HLP help files to CHM with HelpNDoc