Bordering of letters with satin borders is only possible with TTR  

font type. You can create these fonts in the font managementDQ5MB4



Needle: Using the needle definition 1 -19 you can display the border in the 

desired colour on the screen. In the stitch data a “needle change” 

command is inserted. So you can embroider the border in a different colour 

than the filling of the letter. The border is embroidered right after the letter, 

if you want to have a different order, you can change it with the film strip 

under Order of embroidery32ZWMOL 


Distance: Here you can enter the distance of the covering stitches. 


Border width: Here the width of the satin border is defined. If you chose the fill type “ undivided satin” this is also the stitch length. You should not set this value too long, this could cause overlaps of the border lines which will destroy the letter.  


Created with the Personal Edition of HelpNDoc: Effortlessly create a professional-quality documentation website with HelpNDoc