At this point the user defines the Size, alignment, width and colour of the Border.


Proportional height and width:

If this switch is activated, the ratio of width and height 

always remains constant. This means, changing the height 

also changes the width and vice-versa.


Height:        

Used to define the height of the Border in mm. This value 

represents the external height of the border, the internal 

height will be the external height minus twice the Stitch 

width.


Width:        

Used to define the Width of the whole Border in mm. This 

value represents the external width of the border, the 

internal width will be this value minus twice the Stitch width.


Rotation:        

Defines the angle of rotation for the Border. The point about 

which the Border is rotated is the midpoint of the left side of 

the bounding box.


Slanting:        

Defines the Slant angle of the border, the bottom of 

bounding box remains stationary, the top is shifted left or 

right depending upon the angle defined.


TIP:         

The previously described Parameters should only be input, 

in cases where these are strictly defined. Should you want to 

apply a Border to an existing Design, this should be done in 

the working area using the module 

functions2AHF_GA.


Trimming:          

If this switch is set, at the end of the frame a trimming 

command is inserted. This setting is not stored.


Stop:        

If this switch is set, at the end of the frame a Stop command is inserted.


Fixing stitch from: 

Here you can input from which distance to the next element 

there should be a lock stitch at the end of the frame. This 

value is stored.


Trimming from: 

Here you can input from which distance to the next element 

there should be a trimming at the end of the frame. This 

value is stored.


Created with the Personal Edition of HelpNDoc: Free CHM Help documentation generator